A detailed installation guide for a 2010 2011 VW Volkswagen Passat(MK7) car stereo with TV Tuner DVR USB SD 1080P Video DVD Player Bluetooth 3G WIFI

2010 2011 VW Volkswagen Passat(MK7) car stereo after installation

A comfortable driving experience is quite important for every car owner, therefore, more and more car owners are trying to find more ways to relax in cars. One of the easiest and most effective way is to install a new car stereo which can be compatible with many features to offer a lot of convenience and enjoyment to you. Now I’d like to share a step-by-step installation guide about a 2010 2011 VW Volkswagen Passat(MK7) car stereo from Seicane with you. You can refer to it before and during the installation of your new unit.

2010 2011 VW Volkswagen Passat(MK7) car stereo after installation
2010 2011 VW Volkswagen Passat(MK7) car stereo after installation

 

Precautions for this installation:

1.Before you start up any work, park your car well and unplug the negative power cable to avoid any danger.

2.Please make sure that all fastened wires are isolated with electrical tape.

3.Please make sure the ignition is off to avoid short circuit.

 

 

2010 2011 VW Volkswagen Passat(MK7) car stereo installation guide

Step1: Remove the trim panel.

Please pry around the trim panel with a lever. While prying, please loosen the trim panel with your one hand. When the trim panel is loosened, please remove the trim panel off the dashboard and gently place it aside for further removal.

Step 1. Remove the trim panel.
Step 1. Remove the trim panel.

 

Step2: Remove the four screws on the radio.

Please unscrew the four screws which are holding the radio at four corners with a screwdriver. Then keep them well in a small box for the installation of a new head unit.

Step 2. Remove the four screws on the radio.
Step 2. Remove the four screws on the radio.

 

Step3: Take the factory radio out of the dash.

After the four screws are unscrewed, you can easily pull the factory out of the dash.

Step 3. Take the factory radio out of the dash.
Step 3. Take the factory radio out of the dash.

 

Step4: Disconnect the wiring harness.

Before you put the factory radio aside, please disconnect the wiring harness at the back of the factory radio.

Step 4. Disconnect the wiring harness.
Step 4. Disconnect the wiring harness.

 

Step 5: Connect the new Seicane stereo to the original wiring harness as the user manual or the wiring diagram shows.

 

Step 6: Turn on the new Seicane stereo to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.

 

Step 7: Put the new Seicane stereo into the dash and install the four screws.

 

Step 8: Install the trim panel into its original place.

 

After reading this detailed installation guide, do you have a general idea about how to install a new aftermarket 2010 2011 VW Volkswagen Passat(MK7) car stereo? You may have some questions, you can ask your dealer or a professional for help. Besides, it’s vital for you to confirm that your new stereo can fit your car, if you have no idea, you can refer to this modern 2010 2011 VW Volkswagen Passat(MK7) car stereo from Seicane, please click for more details:

 

http://www.seicane.com/aftermarket-radio-gps-navigation-system-for-2008-2011-vw-volkswagen-passat-cc-scirocco-polo-golf-with-dvd-player-bluetooth-3g-wifi-rearview-camera-tv-tuner-dvr-usb-sd-canbus-1080p-video-s127698m

 

This high-end VW Volkswagen Passat(MK7) car stereo comes with the GPS navigation system for you, with the turn-by-turn direction and voice prompts, you can travel around the whole country and easily find a nearby gas station without getting lost any more. To simply sync with your enabled mobile phone, you are able to make and receive hands-free calls and stream music to keep safe and more delightful on all trips. Just take it right now and have a good time from now on!

Leave a Reply

Your email address will not be published. Required fields are marked *